The disadvantages of the traditional dryer

The disadvantages of the traditional dryer

With the develpment of the mining machinery, as we all know that the role of the dryer is more and more important. in addition, every thing has two aspects. so is the dryer. and I think you may know the advantage of the dryer. But do you know the

disadvantages of the traditional dryer?

If you do not know it, I consider that you can spend a little time reading it. the common seven major disadvantages of traditional dryer are as follows:

At first, the drying equipment host installs at a tilt way of near the fire-end high and far fire-end low, which is a extreme mistake. Because the installation methods can speed up the material to the speed of flow is fire, which make the material within the cylinder by storage again reduce, the whole roller to back in thousands of make public the stripper plate simultaneously Yang, but the material of it with few materials raising.

Material in the roller will not be in a “reciprocating movement”, so the materials in the roller will soon be wind pumping away, the result in the material storage cylinder too low, causing material and hot air and the static and dynamic contact area reduced.

In addition, the wind speed in the roller is too slow, causing the material and hot air and the static and dynamic contact strength is flabby, resulting in low efficiency of the drying equipment.

To make the roller dryer too long to improve the yield. If the diameter is too large, the roller will be not fully used,which will cause heat loss;so the equipment covering an area of large is a waste of resource at a certain degree.

What”s more, in order to limit flow speed of materials to the direction of discharging port ,only the rev of the roller limited at a very low, thus roller material being the number of times in the lift was greatly reduced. This causes the material and hot air dynamic contact number is greatly reduced.

The drying of materials is only used the downstream, and in the process of drying can not saturated atmosphere of discharge in time, so that the water vapor in the long distance run inside roller, causing dry material moisture is absorbed again.

At last, the temperature of the feeding and discharging port is too high to improve production, causing a waste of the energy . At the same time also caused by dry material quality drop; Material colour and lustre is serious black; Even the paste a lot.

Of course, maybe my summary is not comprehensive. If you have other supplement, you can comment about my article. We learn from each other, and make progress together. Thank you very much for reading my article. I hope you like it.

rotary drying machine: http://www.mine-crusher.com/dryer.htm